The following table describes the toolbar in the Smart GeoFill window.
| Button | Name | Description |
|---|---|---|
 |
Selection Mode | Click to draw a polygon. Click the arrow at right to select the mode:
Copy copies the pixels in the polygon. Fill copies the pixels from the source polygon to fill the destination polygon. |
 |
Reset Selection | Clear the active polygon and the selected pixels from the display. |
 |
Import Shape | Import an existing polygon. |
 |
Reshape | Reshape the active polygon. |
 |
Blend Exclusion Mask | Use an exclusion mask to constrain a blend. |
 |
Paste | Paste copied pixels. |
 |
Save | Save the result of the Smart GeoFill. |
 |
Undo | Revert to the previous paste. |
 |
Redo | Reapply the last paste to the active image. |
 |
Show Selection Edge | Switch between hiding and showing the selection edge of the active polygon. |
 |
Source Clipping | Switch temporarily between viewing the source pixels constrained by the polygon and the full extents of the source pixels. |
 |
Source Visibility | Switch between viewing the copied source pixels and the original pixels. |
 |
RGB Mapping | Open the RGB Mapping window to manage channel visualization. |
 |
Channel Mapping | Open the Channel Mapping window to map channels and the source of each. |
 |
Open | Open a files or files from which to copy pixels. |
 |
Source File Set | View the selected set of source files (custom or project), and cycle through them to select the one or ones you want.
For more information, see Using a custom file set or Using a project file set, as applicable. |
 |
Previous | View the previous source file. |
 |
Next | View the next source file. |
 |
Number of images | The number of available overlapping images from which to copy pixels. To go to a specific image in the set, type the number of the image you want in the available box, and then press Enter. |