Viewing accepted points

In the Tie Point Collection window, under Accepted Points, you can view the accepted points in the associated image. If necessary, you can change the unit of measure, filter the points being viewed currently, or both. You can also sync any viewers you have open to show the same selection of points.

To change the unit of measure
Beside Residual units, do one of the following:
- To display statistics by using the units of the working image, click Ground.
- To display statistics in pixels, click Pixels.
- To display statistics in microns, click Microns.
The table is updated based on the unit of measure you select.
To filter the display by point type

In the Filter list, clear or select one or more check boxes, as applicable, beside each point type.
You can select from the following:
- Active: Show all active TPs
- Inactive: Show all inactive TPs
- Two-ray: Show TPs that exist only in two images
- Three-ray: Show TPs that exist only in three images
- Four-ray: Show TPs that exist only in four images
- Five-ray: Show TPs that exist only in five images
- Six-ray: Show TPs that exist only in six images
- Seven or More Rays: Show TPs that exist only in seven or more images
Items with a selected check box are displayed, and items with a clear check box are not. By default, All is selected.
To sync the image viewers with the Accepted Points table
- Select the Sync viewers check box.
  The point display of images in any open viewers match the filtered point display in the Accepted Points table. With a clear check box, control over point display is manual.
Note: When you sync viewers with the Accepted Points table, and then clear the Sync viewers check box, the viewers retain the last-selected Filter setting.